Warwick AMPs Instruções de Operação

JONAS HELLBORG SIGNATURES MANUALWARWICK AMPLIFICATION

OPERATING INSTRUCTIONS PREAMP101. IEC Socket and Fuse Holder This is the socket for plug in the line cord. The fuse tray contains the main fuse of the

11PREAMP02SIMPLIFIED SCHEMATIC PREAMP

TECHNICAL SPECIFICATIONS PREAMP12Input sensitivityLevel rangePAD-6dBu to +60dBu-20dBInput ImpedanceHI-ZLO-Z500kΩ600ΩFilter SectionBass Lo-MidHi-MidTre

EQ-GRAPHS PREAMPPREAMP13Hi-MidsF/HzdBLo-MidsF/HzBass/Treble02-20-1001020100 1K 10KdBF/HzdB

POWER AMPLIFIER03

1503POWER AMPLIFIERThe Hellborg Power Amps again are a mix of old and new ideas. They are characterized by their capacities to deliverfast transient a

OPERATING INSTRUCTIONS MONO POWER AMP 250W/500WMONO POWER AMPS16031. Level Control This adjusts the main volume of the amplifier. The CLIP LED above i

OPERATING INSTRUCTIONS MONO POWER AMP 250W/500W1703136541. IEC Socket and Fuse Holder This is the socket for plug in the line cord. The fuse tray cont

STEREO POWER AMP2OPERATING INSTRUCTIONS STEREO POWER AMP 2/250W18031 31. Level Control I & II This adjusts the main volume of each amplifier unit.

03OPERATING INSTRUCTIONS STEREO POWER AMP 2/250W13456721. IEC Socket and Fuse Holder This is the socket for plug in the line cord. The fuse tray conta

FRONT MOUNTINGREAR MOUNTINGMOUNTING OF THE POWER AMPLIFIERS2003The Hellborg Amplifiers are designed for installation in a conventional 19” rack case.

03POWER AMPLIFIER PROTECTIVE CIRCUITSThe new Warwick Jonas Hellborg Power Amplifiers are equipped with a series of circuits to prevent it from destruc

TECHNICAL SPECIFICATIONS POWER AMPLIFIERSPOWER AMPLIFIERS22Specifications Mono Power 250 Mono Power 500 Stereo Power 2/250Input Sensitivity 0dBu 0dBu

SIMPLIFIED SCHEMATIC POWER AMPLIFIERS03STEREO POWER2/250WMONO POWER250/500W23

CABINETS04

2504CABINETSCABINETSThe philosophy behind the cabinets is to through correct cabinet design and use of specifically designed speaker driverscreate cle

CABINETS26CABINETS04Lo CabThe Lo Cab is a low-end complimentto the Hi Cab and the Club Cab. Thesingle Celestion 15-inch speaker iswarm and punchy, add

TECHNICAL SPECIFICATIONS CABINETSTECHNICALSPECIFICATIONSSpecifications Big Cab Club Cab Hi Cab Lo CabType 2x15 direct radiating bandpass cabinet1x15 b

COMBINATION POSSIBILITIESCOMBINATIONS28Club and Lo CabThe Club and Lo Cab can be satisfactory powered by the 250W Mono, the 500W Mono, the 2x250W Ster

05Club & Lo Cab Hi & Big Cab Hi & Lo Cab Big Cab Club CabCOMBINATION POSSIBILITIES

P 04 RECOMMENDATIONP05 INTRODUCTIONPREAMPP 07 PREAMPP 08 QUICK STARTP09-10 OPERATING INSTRUCTIONSP 11 SIMPLIFIED SCHEMETICP 12 TECHNICAL SPECIFICATIO

WIRING EXAMPLESWIRING3005Club & Lo Cab Hi & Big Cab Hi & Lo Cab Big Cab Club CabPreamp & Stereo 2/250WPreamp & 500W & 250WPrea

Headquarters: Warwick GmbH&Co.Music Equipment KG • Gewerbepark 46 • 08258 Markneukirchen/Germany • E-Mail: [email protected] China: Warwick Mu

RECOMMENDATION401RECOMMENDATIONThe following recommendations are to ensure that the device always functions reliably:Never open the casing! To do so w

501INTRODUCTIONGENERAL POINTSWelcome to the Warwick family and congratulations to the purchase of one of our fine Amps. The Jonas Hellborg Series of B

PREAMP02

The centre piece of the “Hellborg Amp System” is the Preamp. The input is a combined ¼”/XLR jack providing both low (XLR) and high (¼”) impedance. Th

QUICK START PREAMPGETTING STARTED8021. Make sure that the Power Amplifier load is matched to the connected loudspeakers load.We recommend using speake

OPERATING INSTRUCTIONS PREAMP1. Input Jack This Neutrik© Combo Connector provides an unbalanced ¼” and balanced XLR input. The ¼” jack is usedfor all